[Silly Little Cars] Seal woes cont...

[TheHomeonbay . via Silly_little_cars]

I drilled and taped the two locating pin holes, put two al;len head cap
screws in with a couple stainless washers and some permatex on the outside
of the seal and no further problems with that  the seal was coated with an
orange rubber material and was finger removable when I had my oil leak I
think the orange coating shrunk over time ... hint access is lots easier if
you remove the "trunk"  assembly . and be ware of the little electronic
doohickey on the rear wall of the engine area  me 08interceptor

On Sun, Sep 13, 2015 at 4:46 PM, sigmaz_1 at yahoo.com <
silly_little_cars at lists.sillylittlecars.com> wrote:

> Started to tear the old girl down again.
>
> Looks like all I've got left is the torque converter bolts, bell housing
> and the top motor mount.
>
>
> It appears that the starter remains on the transmission so that's good
> because the top bolt is a bit difficult to take out without a swivel.
>
>
> Anyone have any pointers, caveats, tips beyond the obvious?
>
>
> I wonder if this seal is obtainable at the local auto parts store ...
>
>
>
>
> _______________________________________________
> Silly Little Cars Email List
> sillylittlecars at sillylittlecars.com
>
> http://lists.sillylittlecars.com/listinfo.cgi/silly_little_cars-sillylittlecars.com
> To unsubscribe, click that link above.
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sillylittlecars.com/pipermail/silly_little_cars-sillylittlecars.com/attachments/20150914/e3e15b16/attachment.htm>